So I finally got around to cranking out the 5 hours of stitching to put this all together. In the end it turned out really well but it could probably have done well with another two card slots. I have also uploaded the files for laser cutting your own leather pieces if anyone would like to make their own. Link to files is HERE.
So If you haven’t seen it before, this is the arcade controller I have built for the game that has been controlling my life. If you can see, there are a whole lot of little blue arrows near the top that don’t look like they are good for sliding the hand across.
I have been working on a more accurate design so I thought, “Why not use arduino and a whole bunch of confusers all wired up in some convoluted way!” So I did..
Shes no prom queen, but even the ugly girls… After a few hours of laser cutting, cleaning, sticking tiny pads of copper, stripping a metric crap ton of wire, and soldering it up all nice, the thing doesn’t work for squat. The wires may be too long, pads too close, or whatever but it does not sense through the acrylic and barely senses when touching the bare copper. My next plan is to re make this same board but with the wires as short as physically possible, no wires touching each other, and maybe if the stars align I will have it working enough for writing the code.